Three lights glow solid on the charging case

Try connecting your product with a different USB cable to determine if there is an issue with the first cable.

Charge times can vary based on the charger. Chargers with a higher current rating generally charge products faster than those with a lower rating. Chargers typically list a current rating on the label in amps (A) or milliamps (mA). A current rating of 1 A / 1000 mA or higher is recommended.

1. Turn off Bluetooth on all devices within 30 ft of the earbuds.
2. Place earbuds in the charging case for 5 seconds.
3. Remove earbuds from the case. The earbuds and charging case should now communicate as normal.

If the battery temperature is beyond the operating temperature range, wait until the product reaches room temperature, then try again.

On a computer, visit btu.bose.com and follow the instructions to ensure your product has the latest features and enhancements. See Updating the software or firmware of your product.

Much like rebooting a smartphone, your product might need to be reset on occasion to correct minor issues. For more info, see Resetting your product.

You can reset the error lights by going to btu.bose.com via a computer:

1. Connect the product to a computer via a USB cable
2. Go to btu.bose.com
3. The application will check the error and clear it automatically. In some cases if your firmware is already up-to-date, you may see a prompt to continue. Click "OK" to reset the error.

Please note: This warning may appear once connected. If so, click "ACCEPT & PROCEED."



If this does not work and the LED state doesn't change, your product will need service.

If the steps provided do not resolve your issue, your product may need service. Follow the link below for more information on how to service your product. Depending on your product and region, you will be provided a contact number or the ability to setup service online.

Click here to start service